Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

I have made a custom PCB using MSP430-FR6047 to measure flow. I wanted to know if it was possible to initialise flow parameters (Parameters under configuration tab in USS Design center) directly ...

I'm developing support for custom flash device "MX25L12833FM2I-10G". I'm having troubles using the flash in 1S-1S-4S. I managed to configure correctly the flash in the 1S-1S-4S protocol. After ...

Hello, I have a question regarding my DSP28377D board. It has been running normally for some time, but occasionally (it has happened many times, with a probability of about 1%) the program fails to ...

I am using CCS version 11 and I would like to use SVN. I tried installing Subversive 4.0.5 from the Eclipse Marketplace, but the SVN Connector did not install properly and it didn't work. I also tried ...

Hi! I am working with INA333 to amplify a wheatstone bridge output voltage. Here is the circuit in KiCAD: I am testing the circuit with the INA output connected to a stm32f405-microcontroller ADC pin.

Please try the steps below to debug this exception . 1. Keep break point in the Master's ISR 2. Note down the R14 Register 3. Search for the R14 register address in the Map file. Here, the address ...

I want to use SBL_SD to initialize my EVM. Could you provide a detailed process on how to flash SBL_SD onto an SD card for booting? By the way, is it sufficient to flash just the ...

Recently, I have updated my board to SDK 10.00.00.08, and I have updated my Docker container accordingly from edgeai-tidl-tools I can compile and run ResNet-18 and MobileNetV2 on my TDA4 board without ...

Even though I enabled this configuration in Theia,I am not able to observe the energy trace in debug mode It appears that the configurations is showing as disabled. Could you please help me with this ...

I was failed to rebuild and download the Lab01 of UCD3138 on CCS. When I downloaded the original .x0 file to UCD3138CC64EVM-030, I can see the string contents through the memory debugger of UCD3138 ...

Customer is working on TDA4AP SDK9.2. They are following the below FAQ to enable the R5f cache ECC. https://e2e.ti.com/support/processors-group/processors/f ...